Changed By: Pedro (Odessa, FL) Change Date: December 23, 2011 01:17PM Re: Removal of camber plates
As jg says, for the front suspension you don't need any special tools. Since you already have PSS9s just release the tension on the springs. Y by lowering the adjustment rings. Then loosen the top end camber plates completely. Press down on the brake rotor and the whole assembly should drop. Replace the camber plates with the upper strut supports. The will fit the shock's shaft. Make sure you use the two large offset washers (one under and one over) the support. Happy Boxstering Pedro
Original Message
Author: Pedro (Odessa, FL) Date: December 23, 2011 12:00AM Re: Removal of camber plates
As jg says, for the front suspension you don't need any special tools. Since you already have PSS9s just release the tension on the springs. Y lowering the adjustment rings. Then loose the top end camber plates completely. Press down on the brake rotor and the whole assembly should drop. Replace the camber plates with the upper strut supports. The will fit the shock's shaft. Make sure you use the two large offset washers (one under and one over) the support. Happy Boxstering Pedro