Show all posts by userPost any parts for sale, or... ... if you're looking for one. |
Well, yesterday I was in a quiet place with the drivers door open and slowly backing up with engine at idle speed listening for this rattle. After several times both moving forward and backward at idle speed, I stalled the engine in reverse, which we all know how that sounds. Clunk! After restarting the engine, and moving forward slowly I could hear rattling that continued until I stopped, and rby Lew - Main Forum
Thanks Andrew, I have used my rubber hammer rapping on the exhaust system from the oxygen sensors back to the exhaust tips. The heat shields seem not to be a problem, and both are tight. There are shields on the exhaust pipes before the cats, and they too seem tight and not rattling. Someone mentioned theirs rusted and became loose causing a annoying rattle. I have been thinking about removing thby Lew - Main Forum
I just cannot believe this rattle is the DMF, or Transmission. The other day after starting the engine, and the car sat in the garage for a few minutes, I started to back out with the engine at idle rpm's around 6 to 7 hundred. When slowly letting out the clutch I hear this rattle. At that engine speed is when things may vibrate, thus rattles might be heard. I don't hear this noise backing upby Lew - Main Forum
Check out this video, it might help you on your repair.by Lew - Main Forum
And that final stretch was 228 mph and it reached that is just a few seconds. Congrats to the Pink Pig!by Lew - Main Forum
QuoteMarcW You have to do more than just change the brake fluid you need to after you have gone around the car in the proper sequence and flushed/bled every caliper then you need to flush/bleed the clutch slave cylinder. I understand on what all you have to do when changing the brake fluid. Each caliper in the proper sequence was bled using my vacuum pump, and the slave cylinder for the clutchby Lew - Main Forum
Thanks for the reply. I am up for the changing the brake fluid next month. I did it myself 2 years ago....My PBS only has 33k miles on it. The Transmission fluid change is on the list. Again thanks for your input. As said earlier the car runs and shifts great and there is no noise at anytime when driving. Just when I stop and shut down the engine I hear the rattle. Not sure how serious this is,by Lew - Main Forum
I am thinking maybe the Dual Mass Flywheel and not the transmission. It shifts perfectly...But what do I know! .by Lew - Main Forum
I have been experiencing a rattling noise when I turn off the engine.....I don't hear the rattling noise when turning off the engine with the clutch pressed in. Is the Dual Mass Flywheel bad?by Lew - Main Forum