Quote
bb1
Hey folks
Looking at some Race Ramps for the Boxster
They advertise as "Unscootable! Won't slip or slide, no matter the surface"....however, I can't find any pictures that show the bottom surface of these on the web.
Can anyone share what that looks like or how well they perform in this regard?
Thanks
Race ramps I don't know.
I had a set of Rhino Ramps for use with among other cars my Boxster. Later I used them with my Cayman S and my 996 Turbo.
The ramps did tend to slide or scoot a bit and this was compounded by the fact I did the work at the office, well, in the shipping bay and the concrete was particular smooth and a bit slick.
The leading edge of the ramp had a rubber under the ramp. I quickly learned to jam the ramp under the rear tire to load that rubber block. Then when I slowly backed the car up the ramps the ramps stayed in place.
If the race ramps don't have the rubber block under the leading edge perhaps you can get a suitably sized piece of relatively thin rubber sheet (like something cut from a roll of rubber floor covering) from a hardware store to put under either the front of the ramp or perhaps even get a larger piece of rubber large enough to put the entire ramp on the sheet of rubber to keep the thing from sliding.
BTW, the ramps would not work under the front of my Porsche cars as the nose of the car was too low and there was too much "overhang". Fortunately I never really had any need to use the ramps to raise the front of the car.
If I had a place to work in my cars I'd skip the ramps and buy a portable lift to use to raise my cars in the air either by lifting the car by its lift points or by driving onto the lift and then lifting the car by its tires/wheels. Never got to the point where I looked into portable car lifts to see if a portable one supported both lifting methods but that's what I would want if it was available.