Show all posts by userDiscussion of Boxsters and other Porsches |
And no I haven't done any work near the master. As I mentioned in the earlier post I did however have my pressure a bit over 22psi, and I totally screwed up and pulled the clutch pedal up, then pushed it down without first relieving pressure at the reservoir.by Tradergarry - Main Forum
Hmm, My Bentley Manual says 22psi. I've serviced my own cars since 1979 and have never encountered this, however I've usually done a 2 person bleed on hydraulics. I actually did increase the pressure a tad, due to fluid/air not sufficiently purging from the slave bleeder. In hindsight I think the bleeder screw with 2 O-rings on the end needs to be opened more than most. I guess I'll repeat thby Tradergarry - Main Forum
Hi Everyone: I replaced clutch slave on 2000 2.7 Boxster. Then pumped pressure to 22 psi. with clutch pedal to floor. Let air out of bleeder valve. Pulled clutch up by hand. Clutch would not go down all the way. At this point I had not relieved pressure from Motive. I pushed a little harder with my hand on clutch pedal. I then noted fluid leaking at slave; but not at bleeder or line. Thenby Tradergarry - Main Forum
Can I install a speed bleeder screw on my clutch slave cylinder? 986 2000 2.7. Is this possible? If so does anyone know the correct size? I removed the plastic bleeder screw from the slave and it has o-rings near the tip. I'm wondering if anyone has successfully used a speed bleeder on the slave and if so the correct size, length, pitch. Thanks, Garryby Tradergarry - Main Forum
Mine works with a fresh battery but batteries die after 3 days. Could it be a short in the key mechanism? Can I get a new circuit board and use my transponder chip?by Tradergarry - Main Forum
Hi Everyone, I'm having trouble locating the cam position sensors on my 2000 2.7 986. Bentley says left front and right rear. But I don't see them. I even removed the air pump and some aos hoses to give more viewing room for right rear and looked with a mirror and light. With other car manuals left is always driver side on US models. Is the info correct? Anyone replaced these on a 2000 2.7?by Tradergarry - Main Forum