Home
>
Main Forum
>
Topic Yes, very similar to the craftsman thing i found. But no T40. I still need the T40 bit.... *NM* |
"Remove nut while counter-holding with torx T-40 screwdriver" - uh, really? grant - Thursday, 25 April, 2013, at 8:45:24 pm |
Re: "Remove nut while counter-holding with torx T-40 screwdriver" - uh, really? Blackbird - Thursday, 25 April, 2013, at 9:24:58 pm |
Thank you! grant - Thursday, 25 April, 2013, at 9:46:12 pm |
Re: Thank you! Blackbird - Thursday, 25 April, 2013, at 9:52:32 pm |
I dreamed i needed that tool ...... grant - Thursday, 25 April, 2013, at 9:56:50 pm |
Pedro - where did you get the tool you pictured.... the bent-end torx driver? *NM* grant - Saturday, 27 April, 2013, at 1:27:14 pm |
Re: Pedro - where did you get the tool you pictured.... the bent-end torx driver? Pedro (Odessa, FL) - Saturday, 27 April, 2013, at 4:45:18 pm |
My access must be different from yours. grant - Saturday, 27 April, 2013, at 4:51:08 pm |
Re: My access must be different from yours. Blackbird - Saturday, 27 April, 2013, at 8:05:18 pm |
Aha. That makes sense. I was... grant - Sunday, 28 April, 2013, at 8:28:39 am |
This should work fine Boxsterra - Sunday, 28 April, 2013, at 9:00:07 am |
Yes, very similar to the craftsman thing i found. But no T40. I still need the T40 bit.... *NM* grant - Sunday, 28 April, 2013, at 10:40:09 am |
It's a standard bit size so you can use almost any set Boxsterra - Sunday, 28 April, 2013, at 11:56:42 am |
Another way Boxsterra - Friday, 26 April, 2013, at 10:05:14 pm |
unfortunately, i dont have compressed air. And access is too tight for an e-impact driver *NM* grant - Saturday, 27 April, 2013, at 9:30:03 am |