Smog check issue. 2000 S. Tony in Whittier - Monday, 10 March, 2014, at 5:27:59 pm |
This should help ... Pedro (Odessa, FL) - Tuesday, 11 March, 2014, at 9:53:29 am |
Can you explain why I have this readiness exception? Tony in Whittier - Tuesday, 11 March, 2014, at 11:14:20 am |
Re: Can you explain why I have this readiness exception? Pedro (Odessa, FL) - Tuesday, 11 March, 2014, at 12:19:15 pm |
The cleaning of the air filter did not affect the readiness monitor states... MarcW - Tuesday, 11 March, 2014, at 1:49:49 pm |
Well, driving a lot around town didn't re-set the readiness mode on the catalyst system... Tony in Whittier - Friday, 14 March, 2014, at 2:24:32 pm |
Thanks guys. I only drove a few miles before the test. The temp. was about 170 degrees. Tony in Whittier - Tuesday, 11 March, 2014, at 4:04:50 pm |
Well, not to put too fine a point on it but it was not good enough. I can't stress... MarcW - Wednesday, 12 March, 2014, at 11:51:06 am |
So does that mean that the catalyst system does not operate when the system has not reached... Tony in Whittier - Wednesday, 12 March, 2014, at 12:47:56 pm |
Re: So does that mean that the catalyst system does not operate when the system has not reached... Pedro (Odessa, FL) - Wednesday, 12 March, 2014, at 6:24:00 pm |
My info is the converter -- a 3-way converter -- doesn't begin to work until around 500F to 600F…. MarcW - Thursday, 13 March, 2014, at 11:15:13 am |
Performed the reset procedure and the readiness code for catalyst is still showing not ready.... Tony in Whittier - Saturday, 15 March, 2014, at 12:46:23 pm |
I've had two out-of-State cars that would not finish the Readiness Test ... Pedro (Odessa, FL) - Sunday, 16 March, 2014, at 11:35:23 am |
I did some research and in California the OBD section of the smog test will pass if.... Tony in Whittier - Tuesday, 18 March, 2014, at 9:11:46 pm |