As jg says, for the front suspension you don't need any special tools.
Since you already have PSS9s just release the tension on the springs by lowering the adjustment rings.
Then loosen the top end camber plates completely.
Press down on the brake rotor and the whole assembly should drop.
Replace the camber plates with the upper strut supports. The will fit the shock's shaft.
Make sure you use the two large offset washers (one under and one over) the support.
Happy Boxstering
Pedro
Pedro Bonilla1998 Boxster 986 - 311,000+ miles:
[www.PedrosGarage.com]
PCA National Club Racing Scrutineer - PCA National HPDE Instructor - PCA Technical Committee (Boxster/Cayman)
Racecar spelled backwards is Racecar
"Racing is life. Anything before or after is just waiting" ... Steve McQueen as Michael Delaney in "LeMans"
"If you wait, all that happens is that you get older"... Mario Andretti
"Being second is to be the first of the ones who lose" ... Ayrton Senna
Edited 1 time(s). Last edit at 12/23/2011 01:17PM by Pedro (Weston, FL).
(
view changes)